Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-19T02:57:32.542Z Has data issue: false hasContentIssue false

Synthesis and Characterization of Cordierite, Mullite and Cordierite-Mullite Ceramic Materials using Coal Fly Ash as Raw Material

Published online by Cambridge University Press:  09 January 2018

J. López-Cuevas*
Affiliation:
CINVESTAV-IPN, Unidad Saltillo, Calle Industria Metalúrgica No. 1062, Parque Industrial Saltillo - Ramos Arizpe, Ramos Arizpe, Coahuila, México, CP 25900
E. Interial-Orejón
Affiliation:
CINVESTAV-IPN, Unidad Saltillo, Calle Industria Metalúrgica No. 1062, Parque Industrial Saltillo - Ramos Arizpe, Ramos Arizpe, Coahuila, México, CP 25900
C.A. Gutiérrez-Chavarría
Affiliation:
CINVESTAV-IPN, Unidad Saltillo, Calle Industria Metalúrgica No. 1062, Parque Industrial Saltillo - Ramos Arizpe, Ramos Arizpe, Coahuila, México, CP 25900
J.C. Rendón-Ángeles
Affiliation:
CINVESTAV-IPN, Unidad Saltillo, Calle Industria Metalúrgica No. 1062, Parque Industrial Saltillo - Ramos Arizpe, Ramos Arizpe, Coahuila, México, CP 25900
*
*Corresponding author; Tel. +52 844 4389600; E-mail address: jorge.lopez@cinvestav.edu.mx
Get access

Abstract

Cordierite (Mg2Al4Si5O18), Mullite (Al4+2xSi2-2xO10-x) and Cordierite-Mullite ceramic materials were obtained from a stoichiometric mixture of coal fly ash (CFA) as a source of SiO2 and Al2O3, plus high-purity MgO and Al2O3. The starting stoichiometric mixtures were homogenized, and then uniaxially pressed, cold isostatically pressed, and sintered at 1200-1600 °C for 2-5 h. The sintered materials were characterized by X-ray diffraction, scanning electron microscopy, Vickers microhardness, density and four-point flexural strength. In general, the desired phases tended to form in the composites at temperatures of 1350 or 1400 °C, with a considerable amount of glassy phase developing from 3 h onwards at one of those two temperatures, depending on the composite composition. The microstructure of the composites consisted of a matrix of Cordierite and interwoven needles of Mullite. The bulk density decreased, while the flexural strength and the Vickers microhardness increased with increasing nominal content of Mullite in the composites. A synergistic effect taking place between Cordierite and Mullite enhances the mechanical properties of the composites.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2018 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable