Hostname: page-component-74656f9884-npj9w Total loading time: 0 Render date: 2026-11-09T19:24:49.479Z Has data issue: false hasContentIssue false

Electrolyte Stability in Vanadium Flow Batteries

Published online by Cambridge University Press:  26 June 2018

D. Noel Buckley*
Affiliation:
Department of Physics, Bernal Institute, University of Limerick, Ireland Department of Chemical and Biomolecular Engineering, Case Western Reserve University, Cleveland OH, USA
Daniela Oboroceanu
Affiliation:
Department of Physics, Bernal Institute, University of Limerick, Ireland
Nathan Quill
Affiliation:
Department of Physics, Bernal Institute, University of Limerick, Ireland
Catherine Lenihan
Affiliation:
Department of Physics, Bernal Institute, University of Limerick, Ireland
Deirdre Ní Eidhin
Affiliation:
Department of Physics, Bernal Institute, University of Limerick, Ireland
Robert P. Lynch
Affiliation:
Department of Physics, Bernal Institute, University of Limerick, Ireland Department of Chemical and Biomolecular Engineering, Case Western Reserve University, Cleveland OH, USA
*
Get access

Abstract

The stability of VFB catholytes was investigated using both light-scattering measurements and visual observation. V2O5 precipitates after an induction time τ which shows an Arrhenius variation with temperature. The value of τ increases with increasing [S] and with decreasing [VV] but the activation energy remains constant with a value of (1.791±0.020) eV. Plots of ln τ against [S] and [VV] show good linearity and the slopes give values of βS = 2.073 M-1 and βV5 = –3.434 M-1 for the fractional rates of variation of τ with [S] and [VV], respectively. Combining the Arrhenius Equation with the observed log-linear variation of τ with [S] and [VV] provides a model for simulating the stability of catholytes. The addition of H3PO4 has a strong stabilizing effect on catholytes at higher temperatures. For example, at 50°C the induction time for precipitation for a typical catholyte is enhanced ∼ 12.5-fold by 0.1 M added H3PO4. At concentrations of H3PO4 less than ∼0.04 M, the precipitation time increases with increasing concentration at all temperatures investigated (30–70°C). At higher concentrations, induction time begins to decrease with increasing concentration of H3PO4: the changeover concentration depends on the temperature. Experiments at 70°C using other phosphate additives (sodium triphosphate, Na5P3O10, and sodium hexametaphosphate, (NaPO3)6) showed similar results to H3PO4.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2018 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable