Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T16:08:25.364Z Has data issue: false hasContentIssue false

Thermal-Spraying of Polymers and Polymer Blends

Published online by Cambridge University Press:  31 January 2011

Get access

Extract

Thermal-spraying of polymers can be traced back to the 1940s, when polyethylene (PE) was first produced by E.I. du Pont de Nemours & Company. Early work with flame-spraying guns was unsuccessful because the equipment, designed for spraying metals, produced a flame that was both too hot and too short to melt the PE without degradation. The technology has advanced considerably in the past 20 years. Flame-spray equipment and hardware accessories have been designed by numerous companies (PFS Thermoplastics, Alamo, Eutectic + Castolin, etc.) specifically for polymeric materials. The new equipment provides either a lower flame temperature or uses special cooling shrouds to cool the center of the flame, providing a longer residence time at a lower temperature. Many plastics can now be completely melted in-flight and allow heat-sensitive components to be coated with plastic.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable