Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-15T21:44:13.130Z Has data issue: false hasContentIssue false

Sample geometry effect on mechanical property of gold micro-cantilevers by micro-bending test

Published online by Cambridge University Press:  05 June 2020

Kosuke Suzuki
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
Tso-Fu Mark Chang*
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
Ken Hashigata
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
Keisuke Asano
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
Chun-Yi Chen
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
Takashi Nagoshi
Affiliation:
National Institute of Advanced Industrial Science and Technology, Tsukuba305-8560, Japan
Daisuke Yamane
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
Hiroyuki Ito
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
Katsuyuki Machida
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
Kazuya Masu
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
Masato Sone
Affiliation:
Institute of Innovative Research, Tokyo Institute of Technology, Yokohama226-8503, Japan
*
Address all correspondence to Tso-Fu Mark Chang at chang.m.aa@m.titech.ac.jp
Get access

Abstract

Sample geometry effects on mechanical strengths of gold micro-cantilevers are evaluated by a micro-bending test. Six micro-cantilevers with the same length of 50 μm are prepared, and the width and the thickness are varied to examine individual effects on the yield stress. The yield stress increases from 428 to 519 MPa when the thickness decreases from 11.1 to 6.0 μm. No obvious dependency is observed when varying the width. The results reveal that the thickness and the width each has a different influence on the yield stresses of micro-cantilevers evaluated by the bending test, which is the sample geometry effect.

Information

Type
Research Letters
Copyright
Copyright © Materials Research Society, 2020

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

Supplementary material: Image

Suzuki et al. supplementary material

Suzuki et al. supplementary material 1

Download Suzuki et al. supplementary material(Image)
Image 194.9 KB
Supplementary material: Image

Suzuki et al. supplementary material

Suzuki et al. supplementary material 2

Download Suzuki et al. supplementary material(Image)
Image 305.2 KB