Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-14T00:53:21.566Z Has data issue: false hasContentIssue false

3d C/C Processing with High Gas Pressure

Published online by Cambridge University Press:  15 February 2011

S. E. Hsu
Affiliation:
Materials Research and Development Center, CSIST, Lungtan,Taiwan 32526 Republic of China
C. I. Chen
Affiliation:
Materials Research and Development Center, CSIST, Lungtan,Taiwan 32526 Republic of China
S. T. Chou
Affiliation:
Materials Research and Development Center, CSIST, Lungtan,Taiwan 32526 Republic of China
Get access

Abstract

Carbon/Carbon composite is densified by Hipping infiltrated pitch. The pore size in matrix decreased as processing pressure increases. The porosity decreasing rate is defined as (Vi−Vi+ 1)/Vi, and is proportional to the applied gas pressure, where Vi and Vi+1 are the pore volume before and after hipping respectively. The bonding strength also increases with the applied gas pressure and with densification cycle. The density of a 67% porosity fiber preform can reach up to 1.9 g/cm3 in less than 6 hipping cycles with maximum gas pressure of 103 Mpa.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable