Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T19:27:55.813Z Has data issue: false hasContentIssue false

3-Dimensional Integration Fabricated by Using Seeded Lateral Epitaxial Film on SiO2

Published online by Cambridge University Press:  21 February 2011

N. Sasaki
Affiliation:
IC Development Division, Fujitsu limited, Kawasaki 211, Japan
T. Iwai
Affiliation:
IC Development Division, Fujitsu limited, Kawasaki 211, Japan
S. Kawamura
Affiliation:
IC Development Division, Fujitsu limited, Kawasaki 211, Japan
R. Mukai
Affiliation:
IC Development Division, Fujitsu limited, Kawasaki 211, Japan
K. Wada
Affiliation:
IC Development Division, Fujitsu limited, Kawasaki 211, Japan
M. Nakano
Affiliation:
IC Development Division, Fujitsu limited, Kawasaki 211, Japan
Get access

Abstract

Seeded lateral epitaxial laser-recrystallization of silicon film on SiO2 is applied to fabricate 3-dimensional (3-D) integrations: 3-D CMOS 7-stage ring oscillators. Top p-channel Si-gate SOI MOSFET's are fabricated in the seeded recrystallized silicon directly above bottom n-channel Si-gate bulk MOSFET's with insulator in between. The recrystallized silicon at the seed region can be utilized for buried contact to interconnect bottom and top MOSFET's. At the arsenic implantation step to fabricate source and drain of the bottom MOSFET's, ions are not implanted into the seed region to prevent heavy doping and crystal disorder there; otherwise the dopant diffuses laterally and residual crystal disorder disturbs the epitaxial recrystallization. After the laser-recrystallization, the seed region is implanted with phosphorus to interconnect the top and bottom MOSFET's.

The Ar+ laser irradiation is performed with a 10 W power, a 50 μm spot size, a 13 cm/s scanning speed and a 13 μm step at 400 °C in air. Propagation delay of 460 psec is obtained for the seven stage 3-D CMOS ring oscillator at a power supply voltage of 17 V for a channel length of 3 μm and a channel width of 18 μm. In the seeded SOI films, grain boundary generation and crystal orientation can be controlled.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable