Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T04:08:14.899Z Has data issue: false hasContentIssue false

Adhesion of Polysilicon Microbeams in Controlled Humidity Ambients

Published online by Cambridge University Press:  10 February 2011

M. P. de Boer
Affiliation:
Dept. 1325, Intelligent Micromachining, Sandia National Laboratories, Albuquerque, NM 87185, mpdebo@sandia.gov, www.mdl.sandia.gov/Micromachine
P. J. Clews
Affiliation:
Dept. 1324, Silicon Processing, Sandia National Laboratories, Albuquerque, NM 87185
B. K. Smith
Affiliation:
Dept. 1324, Silicon Processing, Sandia National Laboratories, Albuquerque, NM 87185
T. A. Michalske
Affiliation:
Dept. 1114, Surface and Interface Science, Sandia National Laboratories, Albuquerque, NM 87185
Get access

Abstract

We characterize in-situ the adhesion of surface micromachined polysilicon beams subject to controlled humidity ambients. Beams were freed by supercritical CO2drying. Consistent adhesion results were obtained using a post-treatment in an oxygen plasma which rendered the microbeams uniformly hydrophilic. Individual beam deformations were measured by optical interferometry after equilibration at a given relative humidity (RH). Validation of each adhesion measurement was accomplished by comparing the deformations with elasticity theory. The data indicates that adhesion increases exponentially with RH from 30% to 95%, with values from 1 mJ/m2 to 50 mJ/m2. Using the Kelvin equation, we show that the data should be independent of RH if a smooth interface is considered. By modeling a rough interface consistent with atomic force microscopy (AFM) data, the exponential trend is satisfactorily explained.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable