Hostname: page-component-7b7567c8c-w7t8q Total loading time: 0 Render date: 2026-11-19T02:34:31.395Z Has data issue: false hasContentIssue false

Amorphous to Microcrystalline Transition in Thickness-graded Hot-Wire CVD Silicon Films

Published online by Cambridge University Press:  01 February 2011

Qi Wang
Affiliation:
Electronic Materials and Device Division National Renewable Energy Laboratory Golden, CO 80401 U.S.A.
John Perkins
Affiliation:
Electronic Materials and Device Division National Renewable Energy Laboratory Golden, CO 80401 U.S.A.
Helio Moutinho
Affiliation:
Electronic Materials and Device Division National Renewable Energy Laboratory Golden, CO 80401 U.S.A.
Bobby To
Affiliation:
Electronic Materials and Device Division National Renewable Energy Laboratory Golden, CO 80401 U.S.A.
Howard M. Branz
Affiliation:
Electronic Materials and Device Division National Renewable Energy Laboratory Golden, CO 80401 U.S.A.
Get access

Abstract

We study the amorphous to microcrystalline silicon phase transition in hot-wire chemical vapor deposition thin-film silicon by depositing a series of unique, thickness-graded, samples on a glass substrate at 200°C. By inserting or withdrawing a motor-driven shutter during growth, we make samples that vary from 200 to about 2000 Å thick across each 5-cm along stripe. Each stripe is grown at a different dilution ratio of hydrogen to silane in the source gas. The phase composition at various locations was determined by Raman and ultraviolet-reflectivity measurements. Atomic force microscopy (AFM) images of topology reveal that the surface changes from a rather smooth a-Si phase to more granular microcrystalline-Si (rms roughness increases from 10 to 47 Å).

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable