Hostname: page-component-7b7567c8c-9cwtv Total loading time: 0 Render date: 2026-11-19T12:08:20.385Z Has data issue: false hasContentIssue false

Analysis of Hydrogen Adsorption in Microporous Adsorbents at Room Temperature and High Pressures

Published online by Cambridge University Press:  25 October 2011

Tyler G. Voskuilen
Affiliation:
School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907, USA
Timothée L. Pourpoint
Affiliation:
School of Aeronautics and Astronautics, Purdue University, West Lafayette, IN 47907, USA
Get access

Abstract

An experimental study of hydrogen adsorption in a variety of high-surface area adsorbent materials has been conducted at room temperature and pressures up to 500 bar on high surface area activated carbons, zeolite templated carbons (ZTC), and metal organic frameworks (MOFs). For all materials, excess hydrogen adsorption isotherms were measured up to 500 bar and have been analyzed in terms of the BET surface area and pore size distribution. The materials were also evaluated for their increase in hydrogen storage density over compressed gas. It was determined that, due to the lower excess adsorption and skeletal densities for the microstructured materials, MOF-177 and ZTC have worse storage densities than compressed gas at most pressures, even when assuming a bed compaction factor of two, while the activated carbons offer marginal increases in storage density over the pressure range investigated.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable