Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T16:43:14.280Z Has data issue: false hasContentIssue false

Can Grain Boundaries Improve the Performance of Cu(In,Ga)Se2 Solar Cells?

Published online by Cambridge University Press:  01 February 2011

Uwe Rau
Affiliation:
u.rau@fz-juelich.de, Forschungszentrum Juelich, IEF-5, Photovoltaics, Photovoltaik, Jülich, 52425, Germany
Uwe Rau
Affiliation:
u.rau@fz-juelich.de, Forschungszentrum Jülich, IEF-5, Photovoltaics, Jülich, 52425, Germany
Get access

Abstract

Two-dimensional numerical device simulations investigate the influence of grain boundaries on the performance of Cu(In,Ga)Se2 solar cells focussing on the question whether or not grain boundaries can improve the efficiency of those devices. The results unveil the following statements: (i) The mere introduction of a grain boundary by adding localized defects into a device that has a high performance from the beginning is not beneficial. (ii) Polycrystalline solar cells can outperform monocrystalline ones, if the total number of defects is equal in both devices. I.e. a given number of recombination centers is better dealt with if these defects are concentrated at the grain boundary rather than homogeneously distributed in the bulk. (iii) A significant improvement of carrier collection via the grain boundaries is found if the bulk of the devices is assumed as relatively poor. In this situation, addition of defects that are not much recombination ac-tive but provide a large charge density at the grain boundaries can improve the device performance. (iv) Passivation of grain boundaries by an internal band offset in the valence band is effective only if the internal barrier amounts at least to 300 meV.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable