Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T10:43:49.213Z Has data issue: false hasContentIssue false

Cl2-Based ECR Etching of InGaP, AlInP and AIGaP

Published online by Cambridge University Press:  10 February 2011

J. Hong
Affiliation:
University of Florida, Gainesville FL 32611
J. W. Lee
Affiliation:
University of Florida, Gainesville FL 32611
S. J. Pearton
Affiliation:
University of Florida, Gainesville FL 32611
C. Santana
Affiliation:
University of Florida, Gainesville FL 32611
C. R. Abernathy
Affiliation:
University of Florida, Gainesville FL 32611
W. S. Hobson
Affiliation:
Lucent Technologies Bell Laboratories, Murray Hill NJ 07974.
F. Ren
Affiliation:
Lucent Technologies Bell Laboratories, Murray Hill NJ 07974.
Get access

Abstract

High microwave power (1000W) Electron Cyclotron Resonance (ECR) Cl2/Ar plasma produce etch rates for In0.5Ga0.5P, Al0.5In0.5P and Al0.5Ga0.5P of ˜1um/min. at low pressure (1.5mTorr), moderate rf power levels (150W) and room temperature. Addition of Cl2 into Ar makes much smoother etched surface morphology as well as increasing the etch rate. All parameters, including microwave power, chamber pressure and rf power increase the etch rate of these alloys. Especially, there is at least a minimum rf power in order to get much higher etch rate with increasing microwave power. AlGaP in Cl2/Ar discharges has lower etch rates than InGaP or AlInP, which is similar to the results based on CH4/H2/Ar plasma chemistries. The Cl2/Ar chemistry enables smooth, high-rate etching without the need for polymer addition and thus simplifies the processing.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable