Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T08:24:58.203Z Has data issue: false hasContentIssue false

Control of Heteroepitaxy in Sol-Gel Derived LiNbO3 Thin Layers

Published online by Cambridge University Press:  15 February 2011

P.G. Clem
Affiliation:
Department of Materials Science and Engineering, Materials Research Laboratory, and Beekman Institute, University of Illinois at Urbana-Champaign, Urbana, IL 61801
D.A. Payne
Affiliation:
Department of Materials Science and Engineering, Materials Research Laboratory, and Beekman Institute, University of Illinois at Urbana-Champaign, Urbana, IL 61801
Get access

Abstract

Lithium niobáte (LiNDO3) in single crystal form is useful for the fabrication of acoustooptic and active waveguide devices. In this paper, the feasibility of integrating LiNbO3 thin layers on sapphire is reported. The performance of signal modulators, surface acoustic wave devices, and second harmonic generators relies on control of crystallographic orientation, so a thin-layer deposition method must meet high standards of crystallographic perfection and optical quality. Solution deposition of lithium niobium ethoxide was evaluated on (110) and (006) sapphire substrates for heteroepitaxy. Atomic force microscopy was used to determine the development of microstructure during the transition from the amorphous to crystalline state. Slab waveguides were formed and evaluated for optical quality and loss. Optical losses in the TEo mode of 500nm (110) LiNbO3 thin layers were determined to be 6 dB/cm. Preliminary results are given for the heteroepitaxial growth of α-Ga2O3 buffer layers.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable