Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-18T23:21:01.468Z Has data issue: false hasContentIssue false

Defects in Silver-Doped Mercuric Iodide Crystals and their Effect on X-Ray and Gamma-Ray Detector Performance

Published online by Cambridge University Press:  21 February 2011

R. B. James
Affiliation:
Advanced Materials Research Department, Sandia National Laboratories, Livermore, CA 94550
X. J. Bao
Affiliation:
Department of Electrical and Computer Engineering, Carnegie Mellon University, Pittsburgh, PA 15213
T. E. Schlesinger
Affiliation:
Department of Electrical and Computer Engineering, Carnegie Mellon University, Pittsburgh, PA 15213
A. Y. Cheng
Affiliation:
EG&G Energy Measurements, Goleta, CA 93116
V. M. Gerrish
Affiliation:
EG&G Energy Measurements, Goleta, CA 93116
Get access

Abstract

The processing steps associated with purification of source material, crystal growth, and attachment of electrical contacts can introduce defects into mercuric iodide (HgI2) that degrade the performance of detectors. We have employed low-temperature photoluminescence (PL) spectroscopy to study radiative recombination centers in the interfacial region between a thin semitransparent film of silver and mercuric iodide. The Ag film was found to introduce a new broad emission band centered at 5490 Å in the photoluminescence spectrum of HgI2. This PL feature can be used as a signature to identify the existence of Ag as a contaminant in HgI2 crystals and detectors. Experiments were also conducted on mercuric iodide surfaces that had been doped with silver, and the results showed that Ag is a rapid diffuser in bulk HgI2. Detectors with silver electrodes were also fabricated and tested using an americium-241 gamma-ray source. Large increases in the leakage currents were observed for the Ag-doped HgI2 devices, indicated that Ag impurities are electrically active in HgI2. These measurements show that silver is unacceptable as an electrode material for mercuric iodide x-ray and gamma-ray detector applications. In addition, they reveal that caution must be taken during handling of mercuric iodide source material, crystals, and detectors to avoid contact with silver, silver compounds, or with any material that contains silver as a contaminant.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable