Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T14:29:58.200Z Has data issue: false hasContentIssue false

Deposition of Conductive Titanium Sub-Oxide Films by Reactive Ion-Beam Sputtering

Published online by Cambridge University Press:  25 February 2011

K.G. Grigorov
Affiliation:
Institut d’Electronique Fondamentale, CNRS URA 0022, Bât. 220, Université Paris Sud, 91405 Orsay Cedex, France
A.H. Benhocine
Affiliation:
Institut d’Electronique Fondamentale, CNRS URA 0022, Bât. 220, Université Paris Sud, 91405 Orsay Cedex, France
D. Bouchier
Affiliation:
Institut d’Electronique Fondamentale, CNRS URA 0022, Bât. 220, Université Paris Sud, 91405 Orsay Cedex, France
F. Meyer
Affiliation:
Institut d’Electronique Fondamentale, CNRS URA 0022, Bât. 220, Université Paris Sud, 91405 Orsay Cedex, France
Get access

Abstract

Titanium monoxide films were deposited on silicon by reactive ion beam sputtering from a Ti target. The film composition was measured in situ by Auger electron spectrometry. It was observed that oxygen content in the deposit does not depend on the substrate temperature, up to 600 °C. Synthesized TiO films had a cubic structure with a lattice parameter of 4.17 Å, which confirmed that the O/Ti concentration ratio in the films was very close to the expected value. The films were found to be conductive, with a resistivity value equal to 170 μΩ cm. They had a yellowish metallic appearence and a very smooth surface. Sequences of annealings at increasing temperatures were performed under ultra-high-vacuum. No AES signal from silicon was observed up to a temperature of 700 °C.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable