Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T02:30:19.342Z Has data issue: false hasContentIssue false

Development of Epitaxial, Tiling, and Cutting Processes for a Diamond Single Crystal Wafer Technology

Published online by Cambridge University Press:  10 February 2011

J. B. Posthill
Affiliation:
Research Triangle Institute, Research Triangle Park, North Carolina 27709-2194
D. P. Malta
Affiliation:
Research Triangle Institute, Research Triangle Park, North Carolina 27709-2194
T. P. Humphreys
Affiliation:
Research Triangle Institute, Research Triangle Park, North Carolina 27709-2194
G. C. Hudson
Affiliation:
Research Triangle Institute, Research Triangle Park, North Carolina 27709-2194
R. E. Thomas
Affiliation:
Research Triangle Institute, Research Triangle Park, North Carolina 27709-2194
R. A. Rudder
Affiliation:
Research Triangle Institute, Research Triangle Park, North Carolina 27709-2194
R. J. Markunas
Affiliation:
Research Triangle Institute, Research Triangle Park, North Carolina 27709-2194
Get access

Abstract

Development of a diamond homoepitaxial deposition process that utilizes water and-ethanol at a growth temperature of ∼600°C is described. Topographies are excellent, and etch-pit densities (EPD) are in the 106 cm-2 range when growth is done on type Ia C(100) substrates.-This process has been used to epitaxially join diamond single crystals that were bonded in close-proximity to each other. This process of “tiling” single crystal diamonds in close proximity in-order to manufacture a large-area diamond single crystal template is also described. Specially-prepared diamonds that have had their faces and edges oriented to { 100} were coated with-heteroepitaxial Ni, then pressed onto a Si wafer while being heated in an inert gas atmosphere.-The resulting bond is excellent; thereby permitting our 600°C diamond deposition process to-epitaxially join the diamonds. A diamond wafer cutting technology has been addressed using a-specific sequence consisting of: ion implantation, homoepitaxial diamond growth, annealing, and-contactless electrochemical etching. This “lift-off” method of cutting has thus far resulted in a 2mm×O.5mm×17.5μm transparent, synthetic, free-standing, single crystal diamond plate being-fabricated. Raman spectroscopy and EPD show the plate to be comparable to our best-homoepitaxial diamond.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable