Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T10:47:20.296Z Has data issue: false hasContentIssue false

Diamond Coatings on Surface-Modified Carbide Tools Using KrF Pulsed Laser

Published online by Cambridge University Press:  10 February 2011

Dong-Gu Lee
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville, FL 32611, dlee@mail.mse.ufl.edu
Rajiv K. Singh
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville, FL 32611, dlee@mail.mse.ufl.edu
Get access

Abstract

The surface of a cemented carbide was modified using a KrF pulsed laser process to achieve a microrough structure, leading to stronger adherence of diamond films to cemented carbide substrates. The surface morphology and roughness were investigated with laser conditions. After the surface modification with the laser and the etching of the modified surface, heat treatment was performed prior to deposition of diamond film in order to observe changes in surface morphology and adhesion. Diamond films were grown by chemical vapor deposition process. The results indicated that the heat treatment of the modified cemented carbide improved the adhesion of diamond films by the recrystallization of tungsten carbides into the fine and long grains. As laser energy for the modification of a cemented carbide increased, the surface roughness increased and tungsten carbide (WC) was transformed to WC1−x(X =0–0.3) and then to W2C.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable