Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T11:50:26.396Z Has data issue: false hasContentIssue false

Dislocation Reduction and Structural Properties of GaN layers Grown on N+-implanted AlN/Si (111) Substrates

Published online by Cambridge University Press:  01 February 2011

Muhammad Jamil
Affiliation:
mjamil@uamail.albany.edu, College on Nanoscale Science and Engineering, University at Albany, NY, Optoelectronics, 255 Fuller Rd,, Albany, NY, 12203, United States, 518-442-2576
James R Grandusky
Affiliation:
jgrandusky@uamail.albany.edu, College of Nanoscale Science and Engineering, University at Albany-State University of New York, Optoelectronics, United States
Vibhu Jindal
Affiliation:
vjindal@uamail.albany.edu, College of Nanoscale Science and Engineering, University at Albany-State University of New York, Optoelectronics, United States
Neeraj Tripathi
Affiliation:
ntripathi@uamail.albany.edu, College of Nanoscale Science and Engineering, University at Albany-State University of New York, Optoelectronics, United States
Fatemeh Shahedipour Sandvik
Affiliation:
sshahedipour@uamail.albany.edu, College of Nanoscale Science and Engineering, University at Albany-State University of New York, Optoelectronics, United States
Get access

Abstract

An alternative scheme to the growth of crack free, dislocation reduced III-Nitride layers on Silicon substrate has been previously introduced that relies on formation of an ion implanted defective layer in the substrate with implantation taking place in the presence of AlN buffer layer. Here, the effects of N+ ion implantation of AlN/Si (111) substrate on the structural and optical properties of the overgrown GaN epilayers have been investigated. Temperature dependent photoluminescence has been used to investigate the impact of the implantation conditions (energy and dose) on optical and structural quality of the GaN overgrown layers. A correlation between PL and high resolution x-ray diffraction (XRD) of the overgrown GaN layers show that the lowest FWHM of bandedge, the highest bandedge to deep defect blue luminescence band ratio, and the lowest symmetric rocking curve FWHM are achieved for the optimized implantation conditions. This correlates well with the results of etch pit density measurement showing an order of magnitude reduction in threading dislocation defect density

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable