Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T11:34:00.676Z Has data issue: false hasContentIssue false

Evaluation of Interface Strength between a Copper Submicron Dot and Silicondioxide Substrate

Published online by Cambridge University Press:  15 March 2011

Hiroyuki Hirakata
Affiliation:
Department of Engineering Physics and Mechanics, Kyoto University, Kyoto 606-8501, Japan
Takayuki Kitamura
Affiliation:
Department of Engineering Physics and Mechanics, Kyoto University, Kyoto 606-8501, Japan
Yoshitake Yamamoto
Affiliation:
Department of Engineering Physics and Mechanics, Kyoto University, Kyoto 606-8501, Japan
Get access

Abstract

An experimental evaluation method of interface strength between ductile submicron-dots and a hard substrate is developed. The validity is examined with copper (Cu) cylindrical dots of submicron scale on a silicondioxide (SiO2) substrate. A hard-layer of tungsten (W) is employed to restrain the deformation and concentrate the stress near the free-edge of Cu/SiO2. A diamond tip is dragged horizontally along the SiO2 surface and the load is applied to the side edge of the W layer at a constant displacement rate using a modified atomic force microscope. Both the lateral and the vertical loads and displacements are continuously monitored during the test. After the tip hits the W layer, the lateral load, F l, increases almost proportionally with the lateral displacement, σl. The Cu dot with the W layer then is clearly separated from the SiO2 along the interface. The restraint by the W layer works well so that there are little damages in both the delaminated W/Cu dot and the substrate. The delamination lateral load, F lC, is successfully evaluated.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable