Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T06:49:41.887Z Has data issue: false hasContentIssue false

Fabrication of Photoluminescent Amorphous Pillar Silicon Structures

Published online by Cambridge University Press:  28 February 2011

S. Lazarouk
Affiliation:
Bielorussian State University of Informatics and Electronics, P. Brovki 6, 220600 Minsk, Belarus
S. Katsuba
Affiliation:
Bielorussian State University of Informatics and Electronics, P. Brovki 6, 220600 Minsk, Belarus
N. Kazuchits
Affiliation:
Bielorussian State University of Informatics and Electronics, P. Brovki 6, 220600 Minsk, Belarus
G. De Cesare
Affiliation:
Rome University, Engineering Faculty, Via Eudossiana, 18,00184 Rome, Italy
S.La Monica
Affiliation:
Rome University, Engineering Faculty, Via Eudossiana, 18,00184 Rome, Italy
G. Maiello
Affiliation:
Rome University, Engineering Faculty, Via Eudossiana, 18,00184 Rome, Italy
E. Proverbio
Affiliation:
Rome University, Engineering Faculty, Via Eudossiana, 18,00184 Rome, Italy
A. Ferrari
Affiliation:
Rome University, Engineering Faculty, Via Eudossiana, 18,00184 Rome, Italy
Get access

Abstract

Fabrication of amorphous pillar silicon structures showing visible photoluminescence (PL) by naked eye is reported. Some attempts involving silicon etching processes were previously performed by other authors, but PL from the resulting pillar structures was never observed.

The pillar silicon structures were grown by Plasma Enhanced Chemical Vapour Deposition (PECVD) of hydrogenated amorphous silicon (a-Si:H) over the surface of porous aluminum oxide films, previously formed by anodization process. Alumina pore dimensions varied between 4-200 nm, depending on the parameters of the anodization process. The size of the grown a-Si:H pillars was quite homogeneous and could be tightly controlled by the anodization conditions. Immediately after PECVD process, PL from the pillar structure was very weak and not visible by naked eye, but after a short electrochemical treatment in 1% wt HF at 2 mA/cm2 it became quite bright and visible at normal daylight. A red shift, very similar to the one shown by porous silicon formed on monocrystalline substrates, was observed during samples drying after the electrochemical treatment.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable