Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T20:07:19.545Z Has data issue: false hasContentIssue false

Finite Element Simulation of Hillock Formation in Aluminum Interconnect

Published online by Cambridge University Press:  26 February 2011

L. G. Burrell
Affiliation:
IBM General Technology Division, Hopewell Junction, New York 12533
S. Kapur
Affiliation:
IBM General Technology Division, Hopewell Junction, New York 12533
I. Shareef
Affiliation:
IBM Research Division, Thomas J. Watson Research Center, Yorktown Heights, NY 10598
Get access

Abstract

A non-linear finite element model has been used to simulate hillock formation in an aluminum interconnect structure. The hillock formation is caused by the thermal expansion mismatch between aluminum and the surrounding SiO2 passivation. Using the ABAQUS software [1], a large strain elastic-plastic-creep analysis was done. The results showed there were stresses large enough to cause yield and permanent deformation of the aluminum interconnect.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable