Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-19T01:54:33.321Z Has data issue: false hasContentIssue false

Fracture Behavior of Silicon Cut with a High Power Laser

Published online by Cambridge University Press:  26 February 2011

C.C. Chao
Affiliation:
Mobil Solar Energy Corporation, Billerica MA 01821
R. Chleboski
Affiliation:
Mobil Solar Energy Corporation, Billerica MA 01821
E.J. Henderson
Affiliation:
Mobil Solar Energy Corporation, Billerica MA 01821
C.K. Holmes
Affiliation:
Mobil Solar Energy Corporation, Billerica MA 01821
J.P. Kalejs
Affiliation:
Mobil Solar Energy Corporation, Billerica MA 01821
T.S. Gross
Affiliation:
Department of Mechanical Engineering, University of New Hampshire, Durham, NH 03824
Get access

Abstract

The fracture twist test is used to obtain the statistical fracture strength distribution for 10-cm square single crystal and polycrystalline silicon wafers cut with a high-power Nd:YAG laser. Tensile wafer edge stresses at fracture are calculated using nonlinear finite element analysis, and the model results are used to examine the limitations of linear torsion and plate theories. The basic hypothesis is that fracture strength of laser-cut wafers is limited by microcracks formed by large residual tensile stresses produced in the cut edge upon cooling after cutting. Differences are found between single crystal CZ and polycrystalline EFG silicon material Weibull parameters characterizing the fracture strength distribution. These indicate that there is a statistical influence of material variables on the fracture strength of the EFG silicon, which lowers its strength and increases the variance of fracture response in comparison to single crystal silicon.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable