Hostname: page-component-7b7567c8c-m6dxt Total loading time: 0 Render date: 2026-11-19T04:45:17.754Z Has data issue: false hasContentIssue false

Glass-Coated, Surface-Modified High-Performance Polymer Fibers

Published online by Cambridge University Press:  15 February 2011

Christian Lietzaua
Affiliation:
University of Massachusetts, Dept. of Polymer Science and Engineering, Amherst, MA 01003
Richard J. Farris
Affiliation:
University of Massachusetts, Dept. of Polymer Science and Engineering, Amherst, MA 01003
Get access

Abstract

High-modulus PPTA and PBZT fibers have been surface-modified by a series of reactions to allow single filaments to be wetted by sodium silicate solutions as well as to exhibit good adhesion to the resulting glass coating. Fiber surfaces have been characterized by X-ray photoelectron spectroscopy. PBZT and PPTA fibers showed little or no decrease of their tensile properties as a consequence of the surface-modification. Glass coatings have been applied to single filaments by dip-coating in an aqueous sodium silicate solution followed by air- and vacuumdrying. Coated PPTA and PBZT fibers with shear moduli as high as 5 GPa have been prepared. The compressive strain at failure of PPTA filaments coated with a 0.5 μm thick air-dried coating was raised to 0.6%, compared to 0.4% for uncoated filaments.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable