Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T00:04:51.291Z Has data issue: false hasContentIssue false

High Density Dry Etching of (Ba,Sr)TiO3 and LaNiO3

Published online by Cambridge University Press:  10 February 2011

K. P. Lee
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville FL 32611
K. B. Jung
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville FL 32611
A Srivastava
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville FL 32611
D. Kumar
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville FL 32611
R. K. Singh
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville FL 32611
S. J. Pearton
Affiliation:
Department of Materials Science and Engineering, University of Florida, Gainesville FL 32611
Get access

Abstract

High density plasma etching of (Ba,Sr)TiO3 (BST) and LaNiO3 (LNO) thin films was performed in two different plasma chemistries, Cl2/Ar and CH4/H2/Ar. While the latter chemistry produced extremely low etch rates (≤ 100 Å-min−1) under all conditions, the Cl2/Ar produced a smooth anisotropic pattern transfer. The etching was still strongly ion-assisted, but maximum removal rates of ∼900 Å min−1 for both materials were achieved with selectivities of ∼16 for BST and ∼7 for LNO over Si. A single layer of thick (∼7 μm) photoresist is an effective mask under these conditions.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable