Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T08:51:14.364Z Has data issue: false hasContentIssue false

Hydrogen Ion Implantation Caused Defect Structures in Heavily Doped Silicon Substrates

Published online by Cambridge University Press:  01 February 2011

Minhua Li
Affiliation:
Fairchild Semiconductor Corporation, FSSL 3333West, 9000 South, West Jordan, Utah 84088, U. S. A.
Q. Wang
Affiliation:
Fairchild Semiconductor Corporation, FSSL 3333West, 9000 South, West Jordan, Utah 84088, U. S. A.
Get access

Abstract

The defects caused by hydrogen ion (H+) implantation were studied for heavily arsenic (As), boron (B), and phosphorous (P) doped (100) silicon substrates. At the implantation energy of 170keV, H+ beam generates defect zones in both arsenic and boron doped silicon wafers. The width of implant damage zone in the heavily As-doped silicon increased from 138nm to 415nm when H+ ion implant dose increased from1×1016 ion//cm2 to 5×1016 ion/cm2, respectively. This dependence is however, opposite in the heavily B-doped substrate. The defect zone decreased with increasing H+ ion dose. The second ion mass spectrometry (SIMS) data show that in both heavily As- and P-doped silicon substrates, hydrogen distribution was governed by both H+-dopant pairing reaction and the amount of the crystal damage, whereas it is exclusively determined by pairing reaction in heavily B-doped silicon substrates. The atomic force microscope (AFM) measurement indicated that the rms roughness of the as-exfoliated surface was 18.86nm, 13.06nm, and 6.79nm for P-, As- and B-doped silicon substrates, respectively. An rms roughness improvement of 20nm-170nm was observed when wafers were annealed at 270°C.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable