Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T20:29:30.258Z Has data issue: false hasContentIssue false

The Influence of Powders and Processing Methods on Microstructure and Properties of Dense Silicon Nitride

Published online by Cambridge University Press:  25 February 2011

G. Woetting
Affiliation:
CFI - Cremer Forschungsinstitut, 8633 Roedental, FRG
H. Feuer
Affiliation:
CFI - Cremer Forschungsinstitut, 8633 Roedental, FRG
E. Gugel
Affiliation:
CFI - Cremer Forschungsinstitut, 8633 Roedental, FRG
Get access

Abstract

Experiments with commercially available as well as with specially prepared Si3N4 -powders were performed in order to estimate the extent of influence of the powder properties and the homogeneity of the additive distribution on the sintering behaviour, the microstructure and on mechanical properties of the dense sintered materials.

The quality of the processing steps was examined by dilatometry which also proved to be a useful tool for deducing appropriate sintering conditions for different Si3N4-powder/additive systems.

The effects of compositional variations and processing on microstructure and mechanical properties are discussed with respect to strength, reliability (Weibull analysis) and fracture toughness. Some important factors to be considered for the production of highperformance, reliable silicon nitride materials and components are pointed out.

The careful analysis of possible influences on the final ceramic resulted in the production of a high-quality Si3N4-material which is used for engine valves, bearing balls, etc.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable