Hostname: page-component-7b7567c8c-9cwtv Total loading time: 0 Render date: 2026-11-19T11:29:54.138Z Has data issue: false hasContentIssue false

Inhomogeneities In Sol-Gel Coatings

Published online by Cambridge University Press:  28 February 2011

B. D. Fabes.
Affiliation:
University of Arizona. Department of Materials Science and Engineering. Tucson. Arizona 85721
D. L. Klein.
Affiliation:
University of Arizona. Department of Materials Science and Engineering. Tucson. Arizona 85721
Get access

Abstract

The structure of sol-gel derived silica coatings was investigated using nanoindentation. chemical etching. and cross-sectional TEM. For coatings heated at 100°C. the surfaces were harder, etched slower, and appeared less porous than the interior of the coatings. For samples fired at higher temperatures (400–800°C). the surfaces remained harder and etched slower than the interior. even though the porosity appeared to be evenly distributed throughout the thickness of the coating. It is proposed that this difference is due to inhomogeneities on two scales in the coatings: bulk porosity and skeletal strain.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable