Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T07:56:02.766Z Has data issue: false hasContentIssue false

Laboratory Testing of Waste Glass Aqueous Corrosion; Effects of Experimental Parameters

Published online by Cambridge University Press:  25 February 2011

W.L. Ebert
Affiliation:
Chemical Technology Division, Argonne National Laboratory, Argonne IL 60439
J.J. Mazer
Affiliation:
Chemical Technology Division, Argonne National Laboratory, Argonne IL 60439
Get access

Abstract

A literature survey has been performed to assess the effects of the temperature, glass surface area/leachate volume ratio, leachant composition, leachant flow rate, and glass composition (actual radioactive vs. simulated glass) used in laboratory tests on the measured glass reaction rate. The effects of these parameters must be accounted for in mechanistic models used to project glass durability over long times. Test parameters can also be used to highlight particular processes in laboratory tests. Waste glass corrosion results as water diffusion, ion exchange, and hydrolysis reactions occur simultaneously to devitrify the glass and release soluble glass components into solution. The rates of these processes are interrelated by the effects of the solution chemistry and glass alteration phases on each process, and the dominant (fastest) process may change as the reaction progresses. Transport of components from the release sites into solution may also affect the observed corrosion rate. The reaction temperature will affect the rate of each process, while other parameters will affect the solution chemistry and the particular processes that are observed during the test. The early stages of corrosion will be observed under test conditions which maintain dilute leachates and the later stages will be observed under conditions that generate more concentrated leachate solutions. Typically, water diffusion and ion exchange reactions dominate the observed glass corrosion in dilute solutions, while hydrolysis reactions are dominant in more concentrated solutions. Which process controls the long-term glass corrosion is not fully understood, and the long-term corrosion rate may be either transport- or reaction-limited.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable