Hostname: page-component-7b7567c8c-48dgx Total loading time: 0 Render date: 2026-11-18T05:46:06.743Z Has data issue: false hasContentIssue false

Laser-Modified Chemical Beam Epitaxy of InGaAs/GaAs Multiple Quantum Wells Using Tris-Dimethylaminoarsenic

Published online by Cambridge University Press:  21 February 2011

H.K. Dong
Affiliation:
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, California 92093–0407
N.Y. Li
Affiliation:
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, California 92093–0407
C.W. Tu
Affiliation:
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, California 92093–0407
Get access

Abstract

We report for the first time laser-modified chemical beam epitaxy (CBE) of InGaAs/GaAs multiple quantum well (MQW) structures using trimethylindium (TMIn), triethylgallium (TEGa), and tris-dimethylaminoarsenic (TDMAAs), a safer alternative to arsine. X-ray rocking curve (XRC) and low-temperature photoluminescence (PL) measurements were used to characterize the pseudomorphic strained quantum well structures. As determined by the X-ray simulation, laser irradiation during the InGaAs well growth was found to enhance the InGaAs growth rate and reduce the indium concentration in the substrate temperature range studied, 440-S00°C, where good interfaces can be achieved. We attribute these changes to laser-enhanced decomposition of TEGa and laser-enhanced desorption of TDMAAs. With laser irradiation, lateral variation of PL exciton peaks was observed, and the PL peaks became narrower.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable