Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T05:02:29.942Z Has data issue: false hasContentIssue false

Leds Based on Oxidized Porous Polysilicon on a Transparent Substrate

Published online by Cambridge University Press:  09 August 2011

C. C. Striemer
Affiliation:
Department of Electrical and Computer Engineering, University of Rochester, Rochester, NY 14627
S. Chan
Affiliation:
Department of Electrical and Computer Engineering, University of Rochester, Rochester, NY 14627
H. A. Lopez
Affiliation:
Department of Electrical and Computer Engineering, University of Rochester, Rochester, NY 14627
K. D. Hirschman
Affiliation:
Department of Electrical and Computer Engineering, University of Rochester, Rochester, NY 14627
H. Koyama
Affiliation:
Department of Electrical and Computer Engineering, University of Rochester, Rochester, NY 14627
Q. Zhu
Affiliation:
Department of Electrical and Computer Engineering, University of Rochester, Rochester, NY 14627
L. Tsybeskov
Affiliation:
Department of Electrical and Computer Engineering, University of Rochester, Rochester, NY 14627
P. M. Fauchet
Affiliation:
Department of Electrical and Computer Engineering, University of Rochester, Rochester, NY 14627
N. M. Kalkhoran
Affiliation:
Spire Corporation, Bedford, MA 01730
L. Depaulis
Affiliation:
Spire Corporation, Bedford, MA 01730
Get access

Abstract

Light emitting devices (LEDs) based on porous polysilicon (PPS) have been fabricated on a transparent quartz substrate. Several structures have been developed, each consisting of a backside contact (ITO or p+ polysilicon), a light emitting PPS layer, a capping layer, and a metal top contact. Photoluminescence (PL) from PPS is similar to that of etched crystalline Si, peaking near 750 nn and showing degradation during 515 nm laser excitation with intensity <100 mW/cm2. This degradation disappears if PPS is oxidized after formation. Visible electroluminescence (EL) has been achieved in both oxidized and non-oxidized PPS devices with voltages under 10 V and current densities <200 mA/cm2.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable