Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T03:33:28.099Z Has data issue: false hasContentIssue false

Mechanical Properties of Cu/Ta Multilayers Prepared by Magnetron Sputtering

Published online by Cambridge University Press:  10 February 2011

Tai D. Nguyen
Affiliation:
Chemistry and Materials Science Department, Lawrence Livermore National Laboratory, Livermore, CA 94550.
Troy W. Barbee Jr.
Affiliation:
Chemistry and Materials Science Department, Lawrence Livermore National Laboratory, Livermore, CA 94550.
Get access

Abstract

The microstructure and mechanical properties of sputtered Cu/Ta multilayers were studied. X-ray diffraction and transmission electron microscopy characterization indicate that both the Ta and Cu in the 2 nm period multilayer are predominantly amorphous, while in longer period samples, the layers are crystalline, with the metastable tetragonal β-Ta observed. No observable microstructure changes upon annealing at 300°C were found. An average Vickers micro-hardness value of about 5.5 GPa was measured, which increases about 5% upon annealing at 300° C. Residual stress in the multilayers and its dependence on thermal annealing are reported. The relationships between microstructure and mechanical properties in the multilayers are discussed.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable