Hostname: page-component-7b7567c8c-p67k6 Total loading time: 0 Render date: 2026-11-19T11:53:05.269Z Has data issue: false hasContentIssue false

Mechanical Quality Factor of Lead Zirconate Titanate/Epoxy Composites

Published online by Cambridge University Press:  01 February 2011

K.C. Cheng
Affiliation:
Department of Applied Physics and Material Research Centre, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong, PR CHINA.
H.L.W. Chan
Affiliation:
Department of Applied Physics and Material Research Centre, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong, PR CHINA.
S.W. Or
Affiliation:
Department of Applied Physics and Material Research Centre, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong, PR CHINA.
C.L. Choy
Affiliation:
Department of Applied Physics and Material Research Centre, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong, PR CHINA.
Get access

Abstract

The mechanical quality factor Q m of 1–3 piezoelectric lead zirconate titanate/epoxy composites with ceramic volume fractions φ ranging from 0.18 to 0.82 has been measured. This range of φ is wider than those previously investigated by other workers. The width-to-thickness ratio of the ceramic phase is sufficiently small that there are no significant mode couplings. The observed Q m agrees well with the prediction of the parallel model. It is found that Q m increases from 34 to 100 as φ changes from 0 to 0.82 and then increases sharply to reach a high value of 600 at φ = 1. Therefore Q m can be tailored to give a wide range of values by varying φ.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable