Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T13:59:18.706Z Has data issue: false hasContentIssue false

Mechanical Stresses in Aluminum and Copper Interconnect Lines for 0.18µm Logic Technologies

Published online by Cambridge University Press:  10 February 2011

Paul R. Besser
Affiliation:
Technology Development Group of Advanced Micro Devices, Inc. One AMD Place, Sunnyvale, CA 94088.Current address: Motorola-AMD Alliance Logic Technology, 3501 Ed Bluestein Blvd, MD K-10, Austin, TX 78721.
Young-Chang Joo
Affiliation:
Technology Development Group of Advanced Micro Devices, Inc. One AMD Place, Sunnyvale, CA 94088.
Delrose Winter
Affiliation:
#AMIA Laboratories (Advanced Materials Instruments and Analysis, Inc.) 7801 North Lamar, Suite C-73, Austin, TX 78752
Minh Van Ngo
Affiliation:
Technology Development Group of Advanced Micro Devices, Inc. One AMD Place, Sunnyvale, CA 94088.
Richard Ortega
Affiliation:
#AMIA Laboratories (Advanced Materials Instruments and Analysis, Inc.) 7801 North Lamar, Suite C-73, Austin, TX 78752
Get access

Abstract

The mechanical stress state of conventional Al and damascene Cu lines of a 0.18 pm logic technology flow have been determined using a novel X-Ray diffraction method that permits measurement of stress on an array of critical-dimension lines on the product die. The effect of high density plasma oxide deposition and the influence of low-K dielectrics on the stress state of the Al lines is described. The effect of materials properties and fabrication methodology on the stress state of damascene Cu lines is shown with measurement of mechanical stress and strain in passivated lines at room temperature and during annealing. The effect of underlayer on the damascene Cu stress state is also quantified.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable