Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T03:33:21.657Z Has data issue: false hasContentIssue false

Micro-Indentation using Strain Rate Sensitivity to Examine Deformation of Polymeric and Metallic Surface Layers

Published online by Cambridge University Press:  15 February 2011

W. R. Newson
Affiliation:
Dept. of Materials and Metallurgical Engineering, Queen's University, Kingston, Ontario, Canada, K7L 3N6
B. J. Diak
Affiliation:
Dept. of Materials and Metallurgical Engineering, Queen's University, Kingston, Ontario, Canada, K7L 3N6
S. Saimoto
Affiliation:
Dept. of Materials and Metallurgical Engineering, Queen's University, Kingston, Ontario, Canada, K7L 3N6
Get access

Abstract

A sensitive method to characterize the inelastic deformation of solids is to measure the thermodynamic response of the deforming volume by applying an inelastic strain rate change. Using the step ramp technique on a displacement controlled micro-indentor with Berkovich tip, the apparent activation volumes were determined for linear low density polyethylene, and eutectic Pb-Sn solder for depths less than 10 μm. The results show that the activation volume is a unique measure of a given microstructure.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable