Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T07:53:43.792Z Has data issue: false hasContentIssue false

Nondestructive Inspection of Thin, Low-Z Samples using Multiplexed Compton Scatter Tomography

Published online by Cambridge University Press:  10 February 2011

B. L. Evans
Affiliation:
Air Force Institute of Technology, Department of Engineering Physics, 2950 P St. Wright-Patterson AFB, OH 45433
J. B. Martin
Affiliation:
Air Force Institute of Technology, Department of Engineering Physics, 2950 P St. Wright-Patterson AFB, OH 45433
L. W. Burggraf
Affiliation:
Air Force Institute of Technology, Department of Engineering Physics, 2950 P St. Wright-Patterson AFB, OH 45433
Get access

Abstract

The viability of a Compton scattering tomography system for nondestructively inspecting thin, low Z samples for corrosion is examined. This technique differs from conventional x-ray backscatter NDI because it does not rely on narrow collimation of source and detectors to examine small volumes in the sample. Instead, photons of a single energy are backscattered from the sample and their scattered energy spectra are measured at multiple detector locations, and these spectra are then used to reconstruct an image of the object. This multiplexed Compton scatter tomography technique interrogates multiple volume elements simultaneously. Thin samples less than 1 cm thick and made of low Z materials are best imaged with gamma rays at or below 100 keV energy. At this energy, Compton line broadening becomes an important resolution limitation. An analytical model has been developed to simulate the signals collected in a demonstration system consisting of an array of planar high-purity germanium detectors. A technique for deconvolving the effects of Compton broadening and detector energy resolution from signals with additive noise is also presented. A filtered backprojection image reconstruction algorithm with similarities to that used in conventional transmission computed tomography is developed. A simulation of a 360–degree inspection gives distortion-free results. In a simulation of a single-sided inspection, a 5 mm × 5 mm corrosion flaw with 50% density is readily identified in 1-cm thick aluminum phantom when the signal to noise ratio in the data exceeds 28.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable