Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-16T18:45:52.338Z Has data issue: false hasContentIssue false

On the Problems with Carbide Formation in Gray Cast Iron

Published online by Cambridge University Press:  21 February 2011

R. B. Gundlach
Affiliation:
AMAX Materials Research Center, Ann Arbor, MI, USA
J. F. Janowak
Affiliation:
Climax Molybdenum Co., Arlington Heights, IL, USA
S. Bechet
Affiliation:
AMAX Europe S.A., Paris, France
K. Rohrigtt
Affiliation:
Climax Molybdenum GmbH, Dusseldorf, W. Germany
Get access

Extract

Gray iron technology has advanced greatly in the past half century. Much has been learned about the mechanisms of nucleation and solidification and about solid state transformations. This information has alloweu gray iron castings to remain competitive for structural components. Low cost and excellent castability make them versatile for a wide variety of industrial components including engine blocks, cylinder heads, housings, manifolds, hydraulic valve bodies and many other castings of similar complexity. Gray cast iron provides the technical advantages of high strength, soundness, good machinability, dimensional stability and uniformity of properties usually required by such cast components. Achieving these characteristics is dependent, however, on achieving proper and uniform structures tnrougnout all sections of the casting. This objective is reaoily attainable in judiciously alloyed gray cast iron.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1985

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable