Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-17T14:35:23.774Z Has data issue: false hasContentIssue false

Optical, Electrical, and Mechanical Characterization of Rapid Thermal Oxidation

Published online by Cambridge University Press:  22 February 2011

C. B. Yarling
Affiliation:
EEESPEC, 201 W. Stassney St., #506, Austin, TX 78745, USA
W. A. Keenan
Affiliation:
WAK Scientific Associates, 6925 Maiden Lane, San Jose, CA 95120, USA
Get access

Abstract

In this study, 6-150mm p-type <100> wafers were cleaned, laser-scribed, and pre-process measured for stress. The wafers were then processed in a tungsten-halogen lamp RTP system with a target Rapid Thermal Oxidation (RTO) thickness of 100Å. Three categories of whole-wafer measurement techniques were used to characterize these wafers: optical, electrical, and mechanical. Optical inspection techniques included spectroscopic reflectometry (reflectivity), and a combination of beam profile reflectometry and beam profile ellipsometry (thickness). Electrical techniques included C-V plotting with a mercury probe (oxide thickness from Cmax, breakdown voltage, and interface trap density) as well as laser-induced photo-current scanning (minority carrier lifetime, minority-carrier diffusion-length). Mechanical inspection included wafer warpage and stress measurements as well as optical imaging inspection using the magic mirror method (damage and defects). Wafer measurements from these instruments (i.e., contour and 3-d maps) are used to characterize integrity of the RTO process.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable