Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T03:03:47.125Z Has data issue: false hasContentIssue false

Orientation Characteristics with Process Parameters of PLZT(X/70/100) Thin Films Prepared by RF-Magnetron Sputtering

Published online by Cambridge University Press:  10 February 2011

S.K. Kang
Affiliation:
Department of Inorganic Materials Engineering, Kyungpook National University, Taegu, Korea
M.S. Park
Affiliation:
Department of Inorganic Materials Engineering, Kyungpook National University, Taegu, Korea
D.B. Kim
Affiliation:
LG Electro-Components Ltd., Osan-City, Kyungki-Do, Korea
K.S. No
Affiliation:
Department of Materials Science and Engineering, KAI ST, Taejon, Korea, skkang@cera.kyungpook.ac.kr
S.H. Cho
Affiliation:
LG Electro-Components Ltd., Osan-City, Kyungki-Do, Korea
Get access

Abstract

PLZT(X/70/100) thin films on MgO(100), Pt/Ti/MgO(100), and Pt/Ti/Si(100) have been prepared by RF-magnetron sputtering process from sintered target with compositions of PLZT(X/70/100), where X=5, 10, and 15, respectively. The effects of substrate temperature, substrate and gas pressure on deposited thin films were studied. Crystalline and surface characterization was analyzed using XRD, SEM, AES, and AFM. X-ray rocking curves were measured to examine the film orientation. It was observed that the gas pressure was the dominant influence on having (001) preferred orientation. As a result, the degree of c-axis orientation increased as gas pressure decreased.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable