Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T18:21:04.308Z Has data issue: false hasContentIssue false

The Physical and Electrical Properties of Polycrystalline Si1−xGex as a Gate Electrode Material for ULSI CMOS Structures

Published online by Cambridge University Press:  14 March 2011

Sung-Kwan Kang
Affiliation:
Dept. of Ceramic Engineering, Yonsei University, Seoul, Korea
Dae-Hong Ko
Affiliation:
Dept. of Ceramic Engineering, Yonsei University, Seoul, Korea
Tae-Hang Ahn
Affiliation:
Hyundai Electronics Industries Co. Ltd., Memory Research & Development Division, Kyungki-do, Korea
Moon-Sik Joo
Affiliation:
Hyundai Electronics Industries Co. Ltd., Memory Research & Development Division, Kyungki-do, Korea
In-Seok Yeo
Affiliation:
Hyundai Electronics Industries Co. Ltd., Memory Research & Development Division, Kyungki-do, Korea
Sung-Jin Whoang
Affiliation:
Ju-Sung Co. Ltd., Kyungki-do, Korea
Doo-Young Yang
Affiliation:
Ju-Sung Co. Ltd., Kyungki-do, Korea
Chul-Joo Whang
Affiliation:
Ju-Sung Co. Ltd., Kyungki-do, Korea
Hoo-Jeong Lee
Affiliation:
Stanford University, Stanford, California 93405, USA
Get access

Abstract

Poly Si1−xGex films have been suggested as a promising alternative to the currently employed poly-Si gate electrode for CMOS technology due to lower resistivity, less boron penetration, and less gate depletion effect than those of poly Si gates. We investigated the formation of poly Si1−xGex films grown by UHV CVD using Si2H6 and GeH4 gases, and studied their microstructures as well as their electrical characteristics. The Ge content of the Si1−xGex films increased linearly with the flux of the GeH4 gas up to x=0.3, and saturated above x=0.45. The deposition rate of the poly Si1−xGex films increased linearly with the flux of the GeH4 gas up to x=0.1, above which it is slightly changed. The resistivity of the Si1−xGex films decreased as the Ge content increased, and was about one half of that of poly-Si films at the Ge content of 45%. The C-V measurements of the MOSCAP structures with poly Si1−xGex gates demonstrated that the flat band voltage of the poly Si1−xGex films was lower than that of poly-Si films by 0.2V.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable