Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T05:55:26.453Z Has data issue: false hasContentIssue false

Plasticity-Related Phenomena in Metallic Films on Substrates

Published online by Cambridge University Press:  15 February 2011

M. Legros
Affiliation:
CEMES-CNRS, 29 rue J. Marvig, 31055 Toulouse -, France
G. Dehm
Affiliation:
MPI fur Metallforschung, Heisenbergstr. 3, 70569 Stuttgart -, Germany
T.J. Balk
Affiliation:
MPI fur Metallforschung, Heisenbergstr. 3, 70569 Stuttgart -, Germany
E. Arzt
Affiliation:
MPI fur Metallforschung, Heisenbergstr. 3, 70569 Stuttgart -, Germany
O. Bostrom
Affiliation:
TECSEN Laboratory, Faculte des Sciences de St Jerome, 13397 Marseille -, France
P. Gergaud
Affiliation:
TECSEN Laboratory, Faculte des Sciences de St Jerome, 13397 Marseille -, France
O. Thomas
Affiliation:
TECSEN Laboratory, Faculte des Sciences de St Jerome, 13397 Marseille -, France
B. Kaouache
Affiliation:
LPM, Ecole des Mines, Parc de Saurupt, 54042 Nancy, France
Get access

Abstract

Plastic deformation due to thermal stresses has been investigated for different metallic films deposited on Si or α-alumina substrates. We conducted post-mortem TEM and SEM investigations of samples that underwent thermal cycles in order to capture the microstructural changes imposed by thermal stresses. The ultimate goal is to determine the dominant plasticity mechanisms responsible for such changes. In-situ thermal cycles performed inside the TEM allowed direct and real-time observations of dislocation behaviour under stress. It is shown that dislocation density drops in Al/Si, Au/Si and in Cu/α-alumina thin film systems. Except in the case of pseudo-epitaxial Cu on sapphire, the interaction of dislocations with the interfaces (passivation, oxide, adhesion layer) is attractive and leads to the disappearance of interfacial dislocations. In this light, the generalized observation of high tensile stresses that arise in metallic films at the end of cooling is explained in terms of insufficient dislocation sources instead of classic strain hardening. Diffusional processes can substitute for a lack of dislocation, but the low relaxation strain rate that would be excpected should lead to high stresses during the cooling stages of thermal cycles.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable