Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T17:16:45.014Z Has data issue: false hasContentIssue false

Polymer Blends made from Ionomer and Ionomer Precursor Polymer

Published online by Cambridge University Press:  10 February 2011

M. A. Bellinger
Affiliation:
Department of Chemical and Biochemical Engineering Rutgers University, Piscataway, NJ 08855–0909
X. Ma
Affiliation:
Department of Chemical and Biochemical Engineering Rutgers University, Piscataway, NJ 08855–0909
L. Tsou
Affiliation:
Department of Chemical and Biochemical Engineering Rutgers University, Piscataway, NJ 08855–0909
J. A. Sauer
Affiliation:
Department of Chemical and Biochemical Engineering Rutgers University, Piscataway, NJ 08855–0909
M. Hara
Affiliation:
Department of Chemical and Biochemical Engineering Rutgers University, Piscataway, NJ 08855–0909
Get access

Abstract

Rigid-rigid blends made of an ionomer and an ionomer precursor polymer, based on either polystyrene (PS) or poly(methyl methacrylate)(PMMA), were studied. A positive deviation from the rule of mixtures in both strength and toughness was observed over the entire composition range; and an especially significant enhancement was observed at low ionomer composition (e.g., 10 wt.%). This is attributed to a fine dispersion of the rigid ionomer phase in the matrix polymer together with good interfacial adhesion between the phases. The adhesion arises from entanglements due to athermal interactions between the same monomeric units of both the ionomer and the ionomer precursor. In addition, all the blend samples are found to be transparent due to similar refractive indices of the two components.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable