Hostname: page-component-7b7567c8c-8tzhz Total loading time: 0 Render date: 2026-11-19T14:14:59.887Z Has data issue: false hasContentIssue false

Practical and Fundamental Studies of Nanocrystalline Composite Thin Films

Published online by Cambridge University Press:  21 February 2011

Yang-Tse Cheng
Affiliation:
General Motors R&D Center, Warren, Michigan 48090–9055
Boqin Qiu
Affiliation:
The University of Wisconsin, Madison, Wisconsin 53706
Simon Tung
Affiliation:
General Motors R&D Center, Warren, Michigan 48090–9055
J. P. Blanchard
Affiliation:
The University of Wisconsin, Madison, Wisconsin 53706
G. Drew
Affiliation:
Packard Electric Division, General Motors, Warren, Ohio 44486
Get access

Abstract

Nanocrytslline composite films of Ag-Mo and Ag-Ni have been made by a co-deposition technique in UHV. The structure and composition have been studied by x-ray diffraction (XRD), transmission electron microscopy (TEM), and electron probe microanalysis (EPMA). For practical applications, the friction coefficient and wear rate were measured using a pin-on-plate machine for Ag-Mo composites deposited on steel. For fundamental studies, the hardness of the Ag-Ni composites deposited on oxidized Si wafers was measured using a nanoindenter. Experiments show that (1) reduction of friction and wear rate can be achieved using these nanocomposite coatings and (2) the hardness of the nanocomposites depends on the grain size. As the grain size of the Ag decreases from 100 to 10 nm, the hardness increases about 4 times.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable