Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T04:58:58.388Z Has data issue: false hasContentIssue false

Preparation of Thin-Foil TEM Specimens from Sub-Millimeter Particulate

Published online by Cambridge University Press:  21 February 2011

Thomas F. Kelly
Affiliation:
Department of Metallurgical and Mineral Engineering, University of Wisconsin, Madison, WI 53706
Matthew R. Libera
Affiliation:
Department of Materials Science and Engineering, MIT, Cambridge, MA 02139.
John B. Vander Sande
Affiliation:
Department of Materials Science and Engineering, MIT, Cambridge, MA 02139.
Get access

Abstract

The particulate produced by many of the methods of rapid solidification, such as atomized powder, is of order 50 microns in diameter and is thus much too small to form the 3mm diameter disc conventionally used for thin-foil microscopy. 50 microns is, however, much too thick for direct TEM study on a support film and grid. A technique is described in detail that produces a composite wafer where atomized metal powder is sandwiched between two layers of electroplated nickel. This wafer is about 25 mm in diameter and about 250 microns thick. 3mm diameter TEM discs can be punched from the wafer and thinned by combinations of grinding, dimpling, jet-polishing, and ion milling. Depending on the composition and structure of the powder under study, the composite nature of the wafer can sometimes promote undesirable galvanic effects during jet polishing and differential thinning rates during ionmilling. Typical results are presented and discussion of the benefits and shortcomings of this technique is made. The method should be applicable to a variety of materials and geometries.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable