Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T10:49:26.914Z Has data issue: false hasContentIssue false

Processing and High Temperature Deformation of Nb3Al

Published online by Cambridge University Press:  01 January 1992

Y. Murayama
Affiliation:
Institute for Materials Research, Tohoku University, Sendai 980, Japan
T. Kumagai
Affiliation:
Now at National Research Institute for Metals, Tokyo 153, Japan
S. Hanada
Affiliation:
Institute for Materials Research, Tohoku University, Sendai 980, Japan
Get access

Abstract

Alloys based on the ordered intermetallic Nb3Al were fabricated by powder metallurgy processing, infiltration processing and clad-chip extrusion processing. By controlling processing variables, single phase Nb3Al and two phase Nb3Al-Nb solid solution alloys were obtained with various microstructures. The single phase Nb3Al deforms by {001 }<100> slip above 1400K and stress-strain curves exhibit deformation softening after showing a high peak stress. Transmission electron microscopic observations revealed that dislocations are dissociated into two partial dislocations which bound a stacking fault and the dissociation width between the partial dislocations depends on aluminum content in Nb3Al. The deformation softening was found to be caused by dynamic recrystallization. The two phase alloy shows similar stress-strain curves to the single phase alloys. However, sub-boundaries and dislocation networks were observed without recrystallized grains.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable