Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T19:28:37.007Z Has data issue: false hasContentIssue false

Properties of Microlaminated Intermetallic-Refractory Metal Composites

Published online by Cambridge University Press:  25 February 2011

R. G. Rowe
Affiliation:
GE Corporate Research and Development, Schenectady, NY 12309
D. W. Skelly
Affiliation:
GE Corporate Research and Development, Schenectady, NY 12309
M. Larsen
Affiliation:
GE Corporate Research and Development, Schenectady, NY 12309
J. Heathcote
Affiliation:
University of California at Santa Barbara, Materials Department, Santa Barbara, CA
G. Lucas
Affiliation:
University of California at Santa Barbara, Materials Department, Santa Barbara, CA
G. R. Odette
Affiliation:
University of California at Santa Barbara, Materials Department, Santa Barbara, CA
Get access

Abstract

Microlaminated composites of Nb3Al-Nb and Cr2Nb-Nb(Cr) were synthesized by high rate magnetron sputtering. Both composites were stable at elevated temperatures. A Cr2Nb-Nb(Cr) composite with 2 µm metal and intermetallic layers had room temperature tensile fracture strength over 725 MPa and a fracture toughness of about 20 MPa√m. Composites with 2 µm and 6 µm thick refractory metal and intermetallic laminations were compared and it was found that layer thickness did not affect fracture toughness. Microlaminates with the thicker 6 µm laminations had lower fracture strength, however. Good fracture strength and high fracture toughness indicated that microlaminated high temperature composites synthesized by vapor phase deposition exhibit the properties predicted by ductile toughening models.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable