Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T10:30:20.449Z Has data issue: false hasContentIssue false

Pulsed Laser Melting of Graphite1

Published online by Cambridge University Press:  26 February 2011

G. Braunstein
Affiliation:
Massachusetts Institute of Technology, Cambridge, MA
J. Steinbeck
Affiliation:
Massachusetts Institute of Technology, Cambridge, MA
M. S. Dresselhaus
Affiliation:
Massachusetts Institute of Technology, Cambridge, MA
G. Dresselhaus
Affiliation:
Massachusetts Institute of Technology, Cambridge, MA
B. S. Elman
Affiliation:
GTE Laboratories, Waltham, MA
T. Venkatesan
Affiliation:
Bell Communications Research, Murray Hill, NJ
B. Wilkens
Affiliation:
Bell Communications Research, Murray Hill, NJ
D. C. Jacobson
Affiliation:
AT&T Bell Laboratories, Murray Hill, NJ
Get access

Abstract

Experimental evidence for laser melting of graphite, by irradiation with 30ns pulses from a ruby laser, is presented. RBS-channeling analysis, Raman scattering and TEM measurements reveal that the surface of graphite melts at a threshold energy density of about 0.6 J/cm2. For laser pulse energy densities above 0.6 J/cm2, the melt front penetration depth increases nearly linearly with increasing energy density. An intense emission of carbon particles during and after irradiation is observed. The thickness of the carbon layer removed in this process also increases nearly linearly with increasing pulse fluence. A dramatic redistribution of ion implanted impurities is also observed. Furthermore, the crystalline structure of the resolidified material is shown to depend on the energy density of the laser pulse. In order to explain these phenomena, a model for laser melting of graphite at high temperatures to form liquid carbon has been developed in which a free electron gas approximation is used to describe the properties of liquid carbon. The model is solved numerically to give the time and depth dependences of the temperature as a function of the laser pulse energy density. Very good agreement is found between the observed melt depth dependence on laser pulse energy density, as determined by RBS-channeling, and the model calculations. The redistribution of ion implanted impurities and the modification of the crystalline structure, caused by the pulsed laser irradiation, are also consistent with the model and permit the determination, for the first time, of interfacial segregation coefficients for impurities in liquid carbon. The model also predicts that liquid carbon at low pressure (p < 1 kbar) has metallic properties.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable