Hostname: page-component-7b7567c8c-p67k6 Total loading time: 0 Render date: 2026-11-19T10:50:21.442Z Has data issue: false hasContentIssue false

Round-Robin Tests of Modulus and Strength of Polysilicou

Published online by Cambridge University Press:  10 February 2011

W. N. Sharpe Jr.
Affiliation:
ME Department, Johns Hopkins University, Baltimore, MD 21218, sharpe@jhu.edu
S. Brown
Affiliation:
Exponent Failure Analysis Associates, Framingham, MA 01701
G. C. Johnson
Affiliation:
ME Department, U. C. Berkeley, Berkeley, CA 94720
W. Knauss
Affiliation:
Aeronautics and Applied Mechanics, Caltech, Pasadena, CA 91125
Get access

Abstract

The Young's modulus and strength of polysilicon specimens manufactured in the same production run were measured in four different laboratories. Specimens subjected to in-plane bending were tested at U. C. Berkeley and at Failure Analysis Associates, and tensile measurements were made at Caltech and Johns Hopkins. All specimens were produced at the Microelectronics Center of North Carolina (MCNC).

In bending, the Young's modulus for specimens nominally 2 µm thick was measured as 174 GPa and 137 GPa; whereas in tension, a value of 132 GPa was obtained. Modulus values of 136 GPa and 142 GPa were measured in tension on specimens nominally 1.5 µm and 3.5 µm thick. Strengths of the brittle polysilicon were 2.8 and 2.7 GPa in bending and 1.3 GPa for both thicknesses in tension.

These preliminary results were presented at Symposium N - Microelectromechanical Structures for Materials Research at the Materials Research Society meeting in April 1998. This paper is a short overview of the test methods — each of which is described elsewhere — and a documentation of the results presented at that time.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable