Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-18T00:41:40.740Z Has data issue: false hasContentIssue false

Silicidation of Titanium-Rich Titanium Boride Deposited by Co-Sputtering on Si (100)

Published online by Cambridge University Press:  14 March 2011

G. Sade
Affiliation:
Department of Materials Engineering, Ben-Gurion University of the Negev, Beer-Sheva, 84105, Israel
J. Pelleg
Affiliation:
Department of Materials Engineering, Ben-Gurion University of the Negev, Beer-Sheva, 84105, Israel
Get access

Abstract

Titanium boride is known as a good diffusion barrier, in particular against copper, however outdiffusion of boron might deteriorate the semiconductor device. A TiSi2 sublayer prevents effectively boron penetration into the Si substrate. In this study the intention was to form a TiB2/TiSi2 bilayer film by silicidation of a titanium-rich titanium boride deposited by magnetron co-sputtering from elemental targets. The TiSi2 formation as well as the redistribution of titanium in the boride layer has been investigated by X-ray diffraction (XRD), Auger depth profiling and cross-sectional transmission electron microscopy (XTEM). Contact structure with Cu metallization was prepared to characterize this structure electrically.

The Ti-rich titanium boride film was completely amorphous by XRD up to 700 °C. Crystallization of Ti-rich silicides (Ti3Si, Ti5Si3) have started at 750 °C, but already at 800 °C crystallization of C54 TiSi2 was completed. TiB2 begins to crystallize at 800 °C. Sheet resistance measurements confirmed these results. The sheet resistance of the as-deposited film was about 16 ω/□ and no significant change was detected up to 700 °C. Then, a remarkable drop in the sheet resistance to ∼1 Ω/□ was obtained after 800 °C, and this value was actually unchanged up to 925 °C. Cross-sectional TEM revealed the formation of the C54 TiSi2 layer between TiB2 and Si and additionally, a second C54 TiSi2 layer was observed within the boride film. Current-voltage measurements of the prepared contact structure showed that it was a Schottky diode with very high leakage current.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable