Hostname: page-component-7b7567c8c-2jgqx Total loading time: 0 Render date: 2026-11-19T17:23:41.621Z Has data issue: false hasContentIssue false

Sintering of Inkjet-printed Cu-nanoparticle Ink in Ambient Conditions Using a Continuous Wave 808 nm Diode Laser

Published online by Cambridge University Press:  28 February 2013

E. Halonen
Affiliation:
Tampere University of Technology, Department of Electronics, Korkeakoulunkatu 3, 33720, Tampere, Finland
S. Koskinen
Affiliation:
Tampere University of Technology, Department of Electronics, Korkeakoulunkatu 3, 33720, Tampere, Finland
I. Leino
Affiliation:
Tampere University of Technology, Department of Electronics, Korkeakoulunkatu 3, 33720, Tampere, Finland
P. Heljo
Affiliation:
Tampere University of Technology, Department of Electronics, Korkeakoulunkatu 3, 33720, Tampere, Finland
M. Mäntysalo
Affiliation:
Tampere University of Technology, Department of Electronics, Korkeakoulunkatu 3, 33720, Tampere, Finland
Get access

Abstract

In this paper, we focused on sintering of inkjet-printed copper nanoparticle ink structures using a continuous wave 808nm diode laser. Laser sintering in printed electronics is a rapid sintering method which enables localized sintering. Sintering of Cu inks is usually done in nitrogen atmosphere but the novelty of this study is that successful sintering of Cu ink was done under ambient conditions. The used ink consists of copper nanoparticles covered with a dispersion agent. Photonic sintering is needed to speed up the sintering process to prevent oxidation during sintering. Electrical and mechanical performance of the printed structures was analyzed. Resistivity of 10-12 μΩcm with good repeatability as well as excellent adhesion, were achieved.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable