Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T08:20:26.734Z Has data issue: false hasContentIssue false

Spherical Load Indentation in Submicron NiTiCu Shape Memory Thin Films

Published online by Cambridge University Press:  01 February 2011

R. Hassdorf
Affiliation:
Center of Advanced European Studies and Research (caesar), D-53175 Bonn, Germany
J. Feydt
Affiliation:
Center of Advanced European Studies and Research (caesar), D-53175 Bonn, Germany
S. Thienhaus
Affiliation:
Center of Advanced European Studies and Research (caesar), D-53175 Bonn, Germany
L. Buforn
Affiliation:
CSM Instruments SA, CH-2034 Peseux, Switzerland
N. Conté
Affiliation:
CSM Instruments SA, CH-2034 Peseux, Switzerland
O. Pykhteev
Affiliation:
Center of Advanced European Studies and Research (caesar), D-53175 Bonn, Germany
M. Kružík
Affiliation:
Center of Advanced European Studies and Research (caesar), D-53175 Bonn, GermanyInstitute of Information Theory and Automation, Academy of Sciences, CZ-182 08 Prague, Czech Republic
N. Botkin
Affiliation:
Center of Advanced European Studies and Research (caesar), D-53175 Bonn, Germany
M. Moske
Affiliation:
Center of Advanced European Studies and Research (caesar), D-53175 Bonn, Germany
Get access

Abstract

Nanoindentation with spherical tipped indenters provides a powerful technique to explore surface and thin film mechanical properties through the application of Hertzian contact mechanics. The full range of mechanical response can be obtained from elastic, through the yield point, to permanent deformation. In this study spherical indentation has been used for probing MBE-grown NiTiCu alloy thin films into superelasticity or stress-induced martensitic transformation. By this way, obstacles typically occurring related to the fabrication of freestanding films (film thickness < 1 μm) are avoided. The indentation measurements were performed starting from the parent austenite state. Notably, for loads as small as 0.5 mN, deformation appears to be completely reversible. As loading is increased (up to 5 mN) the indent becomes irreversible following local plastic deformation within the tip-specimen contact area. Using finite-element simulations the indentation data were converted into a stress-strain diagram aimed at simulating uniaxial tension load. Therefrom, the superelastic strain is estimated to be around 3%.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable