Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T15:41:06.048Z Has data issue: false hasContentIssue false

Structure and Strength of Silica-PDMS Nanocomposites

Published online by Cambridge University Press:  10 February 2011

Adrian Camenzind
Affiliation:
Particle Technology Laboratory, Institute of Process Engineering, Department of Mechanical and Process Engineering, ETH Zurich, Sonneggstrasse 3, CH-8092 Zurich, Switzerland
Thomas Schweizer
Affiliation:
Institute of Polymers, Department of Materials, ETH Zurich, Wolfgang-Pauli-Strasse 10, CH-8093 Zurich, Switzerland
Michael Sztucki
Affiliation:
European Synchrotron Radiation Facility (ESRF), BP 220, F-38043 Grenoble Cedex, France
Sotiris E. Pratsinis
Affiliation:
Particle Technology Laboratory, Institute of Process Engineering, Department of Mechanical and Process Engineering, ETH Zurich, Sonneggstrasse 3, CH-8092 Zurich, Switzerland
Get access

Abstract

Commercially available SiO2 nanoparticles (Aerosil, Degussa) with varying primary particle diameter, specific surface area (SSA), degree of aggregation and structure (fractal dimension) were compounded into PDMS-based nanocomposites. Thin sections of cured nanocomposites were analyzed with TEM and small and ultra-small angle X-ray scattering (U/SAXS) with respect to nanocomposite structure such as: filler primary particle, aggregate (chemically or sinter-bonded particles) and agglomerate (physically-bonded particles). Tensile tests (Young’s modulus) were used to determine the nanocomposite strength which increased with increasing filler volume fraction (up to 12 vol%) consistent with “bound rubber” theory.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable